 |
| MAHLE Aftermarket News |
|---|
 |
9/26/2008
2008 MAHLE Engine Builder Showdown to Premiere on SPEED Channel’s “Two Guys Garage”; Sunday, September 28 at
2:00 p.m. (EST)
 Más
9/4/2008
MAHLE Clevite Canada, ULC Announces Grand Prize Winner of NAPA eLearning™ Promotion
Más
9/4/2008
MAHLE Clevite Introduces Updated eLearning Courses For Clevite Engine Bearings and Perfect Circle Piston Rings
Más
|
| MAHLE Clevite Inc. news. Más |
| MAHLE Aftermarket news. Más | | |
|
|
Clevite® Oil Pump Installation Tips
- Clean the inside of the pan: Anytime work is performed with
the oil pan off, use a suitable solvent to wash the inside of the oil
pan to remove any foreign particles that could later jam the oil pump.
After you wash the pan with solvent, wash the pan with soapy water,
rinse thoroughly and dry.
- Before installing the screen and pick-up tube: It is highly
recommended that you install a NEW screen and pick-up tube with the
installation of a new oil pump. If you must use your old screen and/or
pick-up tube, do not use any solvents to clean either part. The
solvent may be retained in the screen or pick-up tube and cause severe
damage upon initial start-up of the engine.
- Properly install the screen: When installing the screen on
your new oil pump, NEVER use a vise to hold the pump during
installation. Damage to the oil pockets will occur no matter how
gently you may think you are clamping the pump in the vise. By
damaging the oil pockets the oil pump may jam or seize during normal
operation. Always install a new gasket when applications require them.
It is also very important to utilize the correct tools designed to
install press-in design screens. Your local tool supplier will have
these tools available.
- Prime the new oil pump: Adequate lubrication at the start-up
of a rebuilt engine will prevent damage to engine bearings and other
moving parts. Before installing your new oil pump, submerge the pump
in clean engine oil, covering the inlet and turn the pump by hand
until you see oil flow from the outlet of the pump.
- Instructions for mounting the oil pump Where required, always
use a new gasket to mount the pump to the engine block. Tighten the
mounting bolts by hand, making sure that the pump is properly aligned
and seated in place. Finally, using the correct specifications, torque
the mounting bolts with a suitable torque wrench.
- Checking for clearances: When installing your new oil pump,
check the clearance between the crankshaft counterweights and the pump
housing to insure there is no interference. Some engines have a tight
clearance and others may have a wider clearance. Turn the crankshaft
at least one full revolution by hand to check for interference. After
this last check, you will be ready to install the clean oil pan.
- Install a new oil filter: When you install a new oil pump,
you should always install a new oil filter. Debris may become trapped
in other areas of the engine block and a new oil filter will catch any
of the foreign materials that can damage the engine.
|
|
| Buscar |
|---|
|
|
|
|
Lengua
| Imprint
| Contacto